Option 1 : Moulded Hanger

P375_Hanger_Assembly1_500px

Hang the frame from a nail or screw in the wall. The sawtooth pattern on the hanger allows for leveling adjustment.

On poster frames, the hanger may included a strip of foam tape to permanently hold the hanger against the backing.

This method is not recommended for use with our STAS track hanging system. See option (3) for track hanging.

Option 2 : Corner Hanging

P375_Hanging_CornerCLips_500px

Hang the frame from 2 nails or screws in the wall. The sawtooth pattern on the corners allows for some leveling adjustment.

Ensure clips are fully locked into the mouldings before hanging .

This method will not work with our STAS track hanging system. See option (3) for track hanging.

Option 3 : Wire Hanging

P375_Wire_Hanging_Modification_Zoomin_16x20_500px

Profile frames can be hung with suitable framing wire (not included with frame kits) with only a slight modification.

Drill a small hole in the back flanges on two opposite side mouldings as shown.

The holes should be a sufficient distance from the top of the frame to ensure the wire will not protrude from the top when hanging.

String the wire through the holes and twist to form secure loops. The wire should be properly rated to carry the weight of the frame being hung.

P375_Wire_Hanging_Modification_16x20_500px

Adjust the length of wire with the loops to ensure the wire will not protrude from the top when hanging.

This method is ideally suited to display using our STAS track hanging system.